Top Page > Hardware Guide > Paper and Other Media > Paper Recommendations > Types of Paper and Other Media > OHP transparencies
OHP transparencies
Printer setup |
Press the [Menu] key, select [Paper Input], [Paper Type: Bypass Tray], and then select [OHP (Transparency)]. |
Printer driver setup |
Click [Bypass Tray] in "Input Tray:" list, and then click [Transparency] in the "Paper Type:" list. |
Supported paper feed tray |
This paper type can be printed only from the bypass tray. |
Paper capacity |
Make sure paper is not stacked higher than the upper limit mark ( ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray. |
Duplex printing |
Not supported |
Additional cautions |
Printing is slightly slower than when using plain paper.
Due to switching modes, the printer will be on standby for thirty or forty seconds after the job was received.
We recommend that you use a 4000 ANSI lumen or brighter overhead projector to project OHP transparencies.
|