Skip headerimage
ManualsContentsPreviousNextHelp

Replacing the Maintenance Kit

WARNING

  • When replacing the Transfer Unit, turn the main power switch off and wait at least 30 minutes before proceeding with the replacement.

  • When replacing the Fusing Unit, turn the main power switch off and wait at least 30 minutes before proceeding with the replacement.

CAUTION

  • The inside of this printer becomes very hot. Do not touch parts labelled “” (indicating a hot surface).

When to replace the maintenance kit

If the Alert indicator on the control panel lights up and the following message appears on the display, replace the fusing unit and the transcription roller:

“Replace Fusing Unit”

  1. Pull Front Cover Open Lever, and then open the front cover with both hands carefully.

    image

  2. Hold the levers on both sides of the fusing unit and carefully pull it out.

    image

    Place the old fusing unit on a flat surface.

  3. Prepare a new fusing unit.

    image

  4. While supporting both ends of the new fusing unit with your forefingers and pressing down the levers with your thumbs, carefully push the unit fully in.

    image

    image

  5. Make sure that the markings on the fusing unit are aligned with the markings on the levers.

    image

    If the markings are misaligned, align them by lowering the levers and once again pushing the fusing unit fully in.

  6. Slide the levers on the front cover outwards.

    image

  7. Hold both ends of the transfer unit and lift it up.

    image

    Place the transfer unit on a flat surface.

  8. Push the lower right part of the transfer unit.

    image

  9. Lift the transcription roller to take it out.

    image

    image

  10. Hold the new transcription roller, and match it with the transcription unit, like the illustration shown below.

    image

  11. Lift the transcription roller to install it.

    image

    image

  12. Place the transfer unit down on the front cover.

  13. Place the transfer unit on the front cover by aligning the image mark on the transfer unit with the image mark on the front cover.

    image

    image

    Then, push on the green PUSH marks until the transfer unit clicks into place.

    image

  14. Close the front cover with both hands carefully.

    image